Technical Bulletin PAGE: 64/75
Reissued:21-Apr-14
3-5. Slightly lift up the guide rail as you slide it towards the direction indicated with the blue
arrow.
3-6. Release the snap-fit (squared in red in the bottom left photo) and remove the cover to
disclose the aperture (photo bottom right).
3-7. Check if the aperture (indicated in blue in the photos below) is clearly visible.
If the aperture is clogged, clean the area squared in red in the bottom left photo. If a
vacuum cleaner is not in hand, hold the unit so that the aperture faces down and
remove old developer from the unit.
To Next Page
Loading...
