Technical Bulletin PAGE: 16/44
Model: Aries-P1.5/C1.5 Date: 17-Feb-11 No.: RM077018
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Poor connection or defective tray 3, 4 or 5 lift motor
Poor connection or defective tray 3, 4 or 5 lift sensor
Remaining paper or another obstruction has stopped the tray
and motor.
Pick-up solenoid 3, 4 or 5 connector is loose.
Pick-up solenoid 3, 4 or 5 is blocked by an obstruction.
8. Replace the tray 3, 4 or 5 lift motor.
9. Replace the tray 3, 4 or 5 lift sensor.
10. Check or clear obstacles around pick-up solenoid 3, 4, or 5.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
506 B Tray 3 (1st A3 LCT) feed error
507 B Tray 4 (1st A3 LCT) feed error
One of the following conditions is detected in tray 3 or 4 of the 1st
A3 LCT:
The tray 3 or 4 lift sensor is not activated for 10 s after the tray 3
or 4 lift motor turned on.
Upper limit is not detected within 10 s while the paper tray is
lifting during paper feed.
The tray 3 or 4 lift sensor is already activated when tray 3 or 4 is
placed in the machine
Poor connection or defective tray 3 or 4 lift motor
Poor connection or defective tray 3 or 4 lift sensor
Remaining paper or another obstruction has stopped the tray
and motor.
Pick-up solenoid 3 or 4 connector is loose.
Pick-up solenoid 3 or 4 is blocked by an obstruction.
11. Replace the tray 3 or 4 lift motor.
12. Replace the tray 3 or 4 lift sensor.
13. Check or clear obstacles around pick-up solenoid 3 or 4.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
508 B Tray 5 (2nd A3 LCT) feed error
509 B Tray 6 (2nd A3 LCT) feed error
One of the following conditions is detected in tray 5 or 6 of the
2nd A3 LCT:
The tray 5 or 6 lift sensor is not activated for 10 s after the tray
5 or 6 lift motor turned on.
Upper limit is not detected within 10 s while the paper tray is
lifting during paper feed.
The tray 5 or 6 lift sensor is already activated when tray 5 or 6
is placed in the machine
To Next Page
Loading...
