Setting Item Values
03: Setting [Normal]
[High Accuracy]
[Paper Edge Detection Sensor: Distance of Sensors]
Correct the distance between the two paper edge detection sensors when Auto Adjust Image Position is
executed.
Setting Item Max. Value Min. Value Step Unit
04: Correction Value 5.00 -5.00 0.01 mm
[Paper Edge Detection Sensor: Detection Speed]
Correct the detection speed of the paper edge detection sensor for the leading and trailing edges when
Auto Adjust Image Position is executed.
Setting Item Max. Value Min. Value Step Unit
05: Leading Edge/06: Trailing Edge 20.00 -20.00 0.01 %
1103 [Image Position Feedback Correction]
[Correction Mode]
Select the mode for Image Position Feedback Correction. If [Detection Mark] is selected, a mark will be
printed on each corner of the page. Select [Correction Off] if marks are not required.
Setting Item Values
01: Setting [1: Correction Off]
[2: Detection Mark: Back]
[3: Detection Mark: Front & Back]
1104 [Image Position Gap]
To adjust the position manually, use 1104 [Image Position Gap].
[Machine: Image Position]
137
To Next Page
Loading...
