Setting Item Values
06: Process Speed Setting [0:Standard Speed]
[1:Low Speed]
[Speed Adjustment]
Adjust the speed of each motor.
• If the value in "07: Paper Feed Interval Setting" is changed, the interval between each sheet of
paper during printing is increased, resulting in reduced throughput. The lower the value, the greater
the interval becomes.
Setting Item Max. Value Min. Value Step Unit
07: Paper Feed Interval Setting 100 1 1 %
08: Paper Output: Entrance Roller/09:
Decurler Switchback Roller/10: Cooling
Transport Belt
5.0 -5.0 0.1
[Speed Adjustment]
Adjust the speed of each motor.
Setting Item Values
11: Image Detection Feed Speed Mode [0:Standard]
[1:Prevent Misdetection]
1341 [Adjust Paper Curl (Fusing)]
[Speed Adjustment]
Set whether to adjust the warp (curl) of paper in fusing.
• If set to [1:On], the interval between each sheet of paper during printing is increased, resulting in
reduced throughput.
4. Details of Menu Items in Advanced Settings
154
To Next Page
Loading...
