Ricoh Pro C9200 - 1242 [Fusing Pressure Roller on before Fusing]; 1243 [Fusing Pressure Roller on after Fusing]

Setting Item Max. Value Min. Value Step Unit
05: Corct Temp: Initial Feed 30 0 1 deg
06: Corct Temp: Pre-Feed 50
[Initial Sheet Interval]
Adjust the sheet interval by reducing the print speed.
• If the value in this setting is changed, the throughput is reduced because of the increased interval
between printing each sheet immediately after printing starts.
Setting Item Max. Value Min. Value Step Unit
07: Low Temperature: 1 Sided/08: 1
Sided/09: Low Temperature: 2 Sided/10:
2 Sided
3 0 1 None
1242 [Fusing Pressure Roller On Before Fusing]
Set whether make pressure roller contact with the fusing belt or not before printing starts (before feed).
• If set to [1:On], the time taken for adjusting the fusing temperature at the start of printing becomes
longer.
Setting Item Values
01: Setting [0:Off]
[1:On]
1243 [Fusing Pressure Roller On After Fusing]
Set whether make pressure roller contact with the fusing belt or not after printing finishes (after feed).
• If set to [1:On], the time taken for adjusting the fusing temperature at the end of printing becomes
longer.
4. Details of Menu Items in Advanced Settings
144