Ricoh SP 330DN - Maintenance Mode (for Four-Line Lcd Models); Overview

Maintenance Mode (for Four-line LCD Models)
SM 5-1 M0C3/M0C4/M0C5/M0C6/M0C7
System
Maintenance
5. SYSTEM MAINTENANCE
5.1 MAINTENANCE MODE (FOR FOUR-LINE LCD
MODELS)
5.1.1 OVERVIEW
This model has several service menus. Each service menu has several adjustment items.
Maintenance Mode Menu
• Display Info
• Engine Maintenance
• Scan Maintenance (only for MF models)
• Factory Default
• CTL Maintenance
• System Maintenance
• @Remote
Entering the Maintenance Mode
For information on how to enter the "Maintenance Mode", contact the supervisor in your branch
office.
Selecting an Item
To select an item, press the [ ] or [ ] key.
Going into the Next Level/ Returning to the Previous Level
To go into the next level of an item, select an item then press the [OK] key.
To return to the previous level of an item, press the [Back] key.
Exiting the Maintenance Mode Menu
To exit the maintenance mode menu, press the [Clear/Stop] or [Back] key until the "Ready"
display appears.