Ricoh SP 330DN - Control Panel Display; Control Panel Indicator Patterns (Only for Four-Line LCD Models)

Updating the Firmware
SM 5-71 M0C3/M0C4/M0C5/M0C6/M0C7
System
Maintenance
Control Panel Display
The following table lists the control panel display that can appear if an error occurred during a
firmware update, and explains the likely causes of the display and what action to take when
they appear.
Display Likely Cause Solution
The Home screen (touch panel models)
or “Ready” (four-line LCD models) does
not appear on the control panel after one
minute following a firmware update.
A power failure or similar
interruption prevented
the update from
completing.
Refer to "If Initialization
Does Not End Following
a Firmware Update".
Control Panel Indicator Patterns (Only for Four-line LCD Models)
The indicators of the control panel show the machine’s status during and after firmware updates.
If an update fails or does not complete normally, refer to the following table to resolve the
problem.
Indicator Pattern Likely Cause Solution
The Alert and Data in
indicators light up
simultaneously
If the Alert and Data in indicators light up
simultaneously after you turn the machine’s
power back on following a firmware update, the
update did not complete due to a power failure
or similar interruption.
Refer to "If
Initialization Does
Not End Following a
Firmware Update".