Rigol DL3000 Programming Guide

Chapter 2 Command System RIGOL
DL3000 Programming Guide 2-25
Remarks  The current limit refers to the upper limit of the current working in CC mode. Its unit
is A.
 In the setting command, the parameter "MINimum" indicates setting the minimum
current; the parameter "MAXimum" indicates setting the maximum current; and the
parameter "DEFault" indicates setting the default current limit value.
 In the query command, the parameter "MINimum" indicates querying the minimum
current; the parameter "MAXimum" indicates querying the maximum current; and the
parameter "DEFault" indicates querying the default current limit value.
Return
Format
The query returns a real number.
Example :SOUR:CURR:ILIM 5 /*Sets the current limit in CC mode to be 5 A.*/
:SOUR:CURR:ILIM? /*Queries the current limit set in CC mode.*/
[:SOURce]:CURRent:TRANsient:MODE
Syntax [:SOURce]:CURRent:TRANsient:MODE {CONTinuous|PULSe|TOGGle}
[:SOURce]:CURRent:TRANsient:MODE?
Description Sets the transient operation mode in CC mode.
Queries the transient operation mode in CC mode.
Remarks CONTinuous: generates a repetitive pulse stream after the transient generator receives a
trigger signal.
PULSe: generates a single pulse after the transient generator receives a trigger signal.
TOGGle: generates a repetitive pulse stream that toggles between two load levels after the
transient generator receives a trigger signal.
Return
Format
The query returns CONTinuous, PULSe, or TOGGle.
Example
:SOUR:CURR:TRAN:MODE TOGG /*Sets the transient operation mode in CC mode to be
TOGG.*/
:SOUR:CURR:TRAN:MODE? /*Queries the transient operation mode in CC mode.*/
[:SOURce]:CURRent:TRANsient:ALEVel
Syntax
[:SOURce]:CURRent:TRANsient:ALEVel {<value>|MINimum|MAXimum|DEFault}
[:SOURce]:CURRent:TRANsient:ALEVel? [MINimum|MAXimum|DEFault]
Description Sets Level A in transient operation mode.
Queries Level A set in transient operation mode.
Remarks  In transient operation, the sink current toggles between a high value and a low value.
Level A indicates a high value. The unit for Level A is Amphere (A).
 The input value of Level A should be within the set range.
 In the setting command, the parameter "MINimum" indicates setting the minimum
Level A; the parameter "MAXimum" indicates setting the maximum Level A; and the
parameter "DEFault" indicates setting the default value of Level A.
 In the query command, the parameter "MINimum" indicates querying the minimum
Level A; the parameter "MAXimum" indicates querying the maximum Level A; and the

Rigol DL3000 Specifications

General

Brand	Rigol
Model	DL3000
Category	Measuring Instruments
Language	English