Rigol DL3000 Programming Guide

RIGOL Chapter 2 Command System
2-52 DL3000 Programming Guide
:LXI Commands
Command List:
 LXI:IDENtify[:STATE]
 LXI:MDNS[:ENABle]
 LXI:RESet
 LXI:RESTart
LXI:IDENtify[:STATE]
Syntax LXI:IDENtify[:STATE] {0|1|ON|OFF}
LXI:IDENtify[:STATE]?
Description Sets the LXI identifier in the interface to be on or off.
Queries the state of the LXI identifier in the interface.
Remarks  Only when DL3000 is connected to the Internet via the LAN cable, can this command
be effective in setting the LXI identifier to be on.
 Send the
*RST command to restore the instrument to factory defaults, and then the
LXI identifier can be turned off.
Return
Format
The query returns 0 or 1. 0 indicates that the input is off, and 1 indicates that the input is
on.
Example LXI:IDEN:STATE 1 /*Sets the LXI identifier in the interface to be on.*/
LXI:IDEN:STATE? /*Queries the state of the LXI identifier in the interface.*/
LXI:MDNS[:ENABle]
Syntax LXI:MDNS[:ENABle] {0|1|ON|OFF}
LXI:MDNS[:ENABle]?
Description Sets MDNS to be on or off.
Queries the state of MDNS.
Remarks  Only when DL3000 is connected to the Internet via the LAN cable, can this command
be effective in setting the LXI identifier to be on.
 Send the
*RST command to restore the instrument to factory defaults, and then the
MDNS can be disabled.
Return
Format
The query returns 0 or 1. 0 indicates that the input is off, and 1 indicates that the input is
on.
Example LXI:MDNS:ENAB 1 /*Sets MDNS to be on.*/
LXI:MDNS:ENAB? /*Queries the state of MDNS.*/

Rigol DL3000 Specifications

General

Brand	Rigol
Model	DL3000
Category	Measuring Instruments
Language	English