RIGOL
User’s Guide for DM3058
6. Press Add button, input the second group of reference value: 112.570Ω、32.5℃
Figure 3-21
Input the second group of reference value
7. When finishing this group of reference value, press Done button, save all
changes, and continue to input other values.
Figure 3-22 Edit interface of reference value
It allows deleting and editing the reference values that had been entered, select the
group of reference value then press Del or Edit to perform the operations required.
When you finish inputting all the data, press and save all the changes, back to a
higher level menu.
8. Press Done Apply, save all the data into the local storage, and applies
it immediately
Figure 3-23 Finish interface
9. Press Save to load Sensor’s file has been set to the Memory of DM3058. For the
details please refer to Storage and Recall.
Select Apply to load settings into current Sensor and use it directly.
Figure 3-24 Apply interface
10. Press Show and select Display mode of measurement result as Full to view
To Next Page
Loading...
