Rigol DS1054Z Programming Guide

RIGOL Chapter 2 Command System
2-4 MSO1000Z/DS1000Z Programming Guide
:ACQuire Commands
The :ACQuire commands are used to set and query the memory depth, acquisition mode and the number of
averages as well as query the current sample rate of the oscilloscope.
Command List
[1]
:
 :ACQuire:AVERages
 :ACQuire:MDEPth
 :ACQuire:TYPE
 :ACQuire:SRATe?
Note
[1]
: In the "Command List" in this manual, the parameters in the setting commands and the query commands are
not included and you can refer to the complete introductions of the commands in the text according to the keywords.
:ACQuire:AVERages
Syntax
:ACQuire:AVERages <count>
:ACQuire:AVERages?
Description
Set or query the number of averages under the average acquisition mode.
Parameter
Name
Type
Range
Default
<count>
Integer
2
n
(n is an integer from 1 to 10)
2
Explanation
 You can sent the :ACQuire:TYPE command to set the acquisition mode.
 In the average acquisition mode, greater number of averages can lower the noise
and increase the vertical resolution, but will also slow the response of the displayed
waveform to the waveform changes.
Return
Format
The query returns an integer between 2 and 1024.
Example
:ACQuire:AVERages 128 /*Set the number of averages to 128*/
:ACQuire:AVERages? /*The query returns 128*/

Rigol DS1054Z Specifications

General

Channels	4
Bandwidth	50 MHz
Sample Rate	1 GSa/s
Memory Depth	24 Mpts
Display	7 inch TFT LCD (800x480)
Vertical Sensitivity	1 mV/div to 10 V/div
Time Base Range	5 ns/div to 50 s/div
Vertical Resolution	8 bits
Trigger Types	Edge, Pulse, Video, Slope
Connectivity	USB Host, USB Device, LAN
Input Impedance	1 MΩ
Power Supply	100-240 VAC, 45-440 Hz