Chapter 3 Programming Demos RIGOL
MSO1000Z/DS1000Z Programming Guide 3-3
Excel Programming Demo
The program used in this demo: Microsoft Excel 2010
The function realized in this demo: send the *IDN? Command to read the device information.
1. Create a new Excel file that enables the Macros. In this demo, the file is named as IDN.xlsm.
2. Run the IDN.xlsm file. Click FileOptions at the upper-left corner of the Excel file to open the
interface as shown in the figure below. Click Customize Ribbon at the right, check Developer and
click OK. At this point, the Excel menu bar displays the Developer menu.
To Next Page
Loading...
