Rigol DS1104Z Plus Programming Guide

Chapter 2 Command System RIGOL
MSO1000Z/DS1000Z Programming Guide 2-29
:CURSor:AUTO
Command List:
 :CURSor:AUTO:ITEM
 :CURSor:AUTO:AX?
 :CURSor:AUTO:BX?
 :CURSor:AUTO:AY?
 :CURSor:AUTO:BY?
 :CURSor:AUTO:AXValue?
 :CURSor:AUTO:AYValue?
 :CURSor:AUTO:BXValue?
 :CURSor:AUTO:BYValue?
:CURSor:AUTO:ITEM
Syntax
:CURSor:AUTO:ITEM <item>
:CURSor:AUTO:ITEM?
Description
The auto cursor function can measure 37 waveform parameters. Using this command,
you can select the parameters to be measured by the auto cursor from the five
parameters enabled last or query the parameters currently measured by the auto cursor.
Parameter
Name
Type
Range
Default
<item>
Discrete
{OFF|ITEM1|ITEM2|ITEM3|ITEM4|ITEM5}
OFF
Explanation
 This command is only valid when the auto cursor mode is selected. You can select
the auto cursor measurement mode using the :CURSor:MODE command.
 The 37 waveform parameters are listed below (see the detailed introduction
in :MEASure Commands). The parameters can be enabled by the :MEASure:ITEM
command.
Period, Frequency, Rise Time, Fall Time, +Width, -Width, +Duty, -Duty, +Pulses,
-Pulses, +Edges, -Edges, tVmax, tVmin, +Rate, +Rate, Delay 1→2, Delay
1→2, Phase 1→2, Phase 1→2, Vmax, Vmin, Vpp, Vtop, Vbase, Vamp,
Vupper, Vmid, Vlower, Vavg, Vrms, Overshoot, Preshoot, Area, Period Area, Period
Vrms, Variance.
Return
Format
The query returns OFF, ITEM1, ITEM2, ITEM3, ITEM4, or ITEM5.
Example
:CURSor:AUTO:ITEM ITEM3 /*Use auto cursor to measure ITEM3*/
:CURSor:AUTO:ITEM? /*The query returns ITEM3*/

Rigol DS1104Z Plus Specifications

General

Bandwidth	100 MHz
Channels	4
Sample Rate	1 GSa/s
Memory Depth	24 Mpts
Waveform Capture Rate	30, 000 wfms/s
Vertical Sensitivity	1 mV/div to 10 V/div
Timebase Range	5 ns/div to 50 s/div
Connectivity	USB Host, USB Device, LAN, AUX
Vertical Resolution	8 bits
Power Supply	100-240 V AC, 45-440 Hz
Display	7 inch TFT LCD
Trigger Types	Edge, Pulse, Video, Slope
Input Impedance	1 MΩ ± 2%