Rigol DS1104Z Plus

RIGOL Chapter 2 Command System
2-62 MSO1000Z/DS1000Z Programming Guide
:DISPlay Commands
The :DISPlay commands can be used to set the waveform display mode, persistence time, waveform
intensity, screen grid type and grid brightness.
Command List:
 :DISPlay:CLEar
 :DISPlay:DATA?
 :DISPlay:TYPE
 :DISPlay:GRADing:TIME
 :DISPlay:WBRightness
 :DISPlay:GRID
 :DISPlay:GBRightness
:DISPlay:CLEar
Syntax
:DISPlay:CLEar
Description
Clear all the waveforms on the screen.
Explanation
 If the oscilloscope is in the RUN state, waveform will still be displayed.
 This command is equivalent to pressing the CLEAR key at the front panel. Sending
the :CLEar command can also clear all the waveforms on the screen.
Related
Command
:RUN