Rigol DS2000E Series - Page 275

Chapter 16 Specifications RIGOL
DS2000E User’s Guide
16-5
Byte Length 1 to 5
SPI Trigger
Trigger Condition Timeout
Timeout Value 100 ns to 1 s
Data Bits 4 bits to 32 bits
Data Setting H, L, X
CAN Trigger (Optional)
Signal Type Rx, Tx, CAN_H, CAN_L, Differential
Trigger Condition SOF, EOF, Frame Type, Frame Error
Signal Rate 10 kbps, 20 kbps, 33.3 kbps, 50 kbps, 62.5 kbps, 83.3 kbps,
100 kbps, 125 kbps, 250 kbps, 500 kbps, 800 kbps, 1 Mbps,
User
Sample Points 5% to 95%
Frame Type Data, Remote, Error, OverLoad
Error Type Bit Fill, Answer Error, Check Error, Format Error, Random Error
USB Trigger (Optional)
Signal Speed Low Speed, Full Speed
Trigger Condition SOP, EOP, RC, Suspend, Exit Suspend
Measure
Cursor
Manual Mode
Voltage Deviation between Cursors (
△
V)
Time Deviation between Cursors (
△
T)
Reciprocal of
△
T (Hz) (1/
△
T)
Track Mode Voltage and Time Values of the Waveform
Point
Auto Mode Allow to display cursors during auto
measurement
Auto
Measurement
Maximum, Minimum, Peak-Peak Value, Top Value, Bottom
Value, Amplitude, Average, Vrms-N, Vrms-1, Overshoot,
Pre-shoot, Area, Period Area, Frequency, Period, Rise Time,
Fall Time, Positive Pulse Width, Negative Pulse Width, Positive
Duty Cycle, Negative Duty Cycle, Delay A B , Delay
A
B , Delay A B , Delay A B , Phase A B ,
Phase A
B , Phase A B , Phase A B
Number of
Measurements
Display 5 measurements at the same time