Rigol DSA1030A series - Figure 2-21 Interface of Harmo Dist Measurement

Front Panel Key Reference RIGOL
User’s Guide for DSA1000 Series
2-69
2.4.2.7 Harmo Dist
Figure 2-21 Interface of Harmo Dist measurement
Result:
The results under this mode contain the amplitude of each harmonic and THD. Up to
10 times harmonics can be measured.
Parameters:
In this mode, setting parameters are Avg Num, Avg Mode, NO.of Harmo and
Harmonic ST (Sweep Time).
1. Avg Num
Sets the average number for the measurement, the default is Off.
You can use the numeric keys, knob or direction keys to modify this parameter.
For more details, please refer to “Parameter Input”.