Rigol DSA1030A series - Figure 2-14 Power Sweep

RIGOL Front Panel Key Reference
2-44 User’s Guide for DSA1000 Series
Key Points:
 This parameter only changes the readout of the TG output power, rather than the
actual value of it.
 The offset could be either a positive (gain) or a negative (loss).
 You can use the numeric keys, knob or direction keys to modify this parameter.
For more details, please refer to “Parameter Input”.
Table 2-25 TG Level Offset
Parameter
Explanation
Default
0 dB
Range
-200 dB to 200 dB
Unit dB
Knob Step 1 dB
Direction Key Step 10 dB
2.3.4.4 Power Sweep
Enables or disables the power sweep function. If enabled, the power from the TG
varies with the sweep rate of the analyzer within the specified range (from start to
stop frequency) and increases gradually starting from the specified TG power (see
“TG level”) within specified power range (see “Power Range”). If disabled, the TG
output is fixed at the specified power (see “TG level”).
Freq (Hz)
Ampl (dBm)
Start Freq Stop Freq
TG Output
TG Level
Power
Range
Figure 2-14 Power sweep