Rigol DSA1030A series - Preset

RIGOL Front Panel Key Reference
2-104 User’s Guide for DSA1000 Series
2.6.3 Preset
Restores the analyzer to a specified status. This may change all parameters related to
the sweep, the measurement function and the system.
Key Points:
 Press System  Reset  Preset Type to select Factory or User.
 Press Preset to load Factory settings (except for items marked with “**”) listed
in the following table or User-defined settings.
Table 2-65 Factory Default
Parameter Default
Frequency
Center Freq 1.5 GHz
Start Freq 0 Hz
Stop Freq 3 GHz
CF Step Auto, 300 MHz
Signal Track Off
Span
Span 3 GHz
Amplitude
Ref Level 0 dBm
Ref Offset 0 dB
Scale/Div 10 dB
Input Atten Auto, 10 dB
Scale Type Log
Units dBm
RF Preamp*** Off
MaxMixL -10 dBm
Corr
Corrections Off
Detector
Detector Type Pos Peak
Demod
Demod Off
Speaker Off