Rigol DSA1030A series - Continue

RIGOL Front Panel Key Reference
2-32 User’s Guide for DSA1000 Series
2.2.6 Continue
Sets the sweep mode to Continue.
Key Points:
 If the instrument is in Single sweep mode and no measurement function is
enabled, pressing this key will enter the Continue mode and execute specified
number of sweeps on the condition that all trigger conditions are satisfied.
 If the instrument is in Single sweep mode and a measurement function is on,
pressing this key will enter the Continue sweep mode and execute specified
number of measurements on the condition that all trigger conditions are satisfied.
 In Continue mode, the system will send a trigger initialization signal automatically
and enter the trigger condition judgment directly.
Enter Continue Sweep
mode and Wait for
Trigger Condition
Sweep Again and Wait for
Trigger Condition
Press
Continue
Single Sweep
status
？
Y
N
Figure 2-12 Process of continue sweep