RIGOL Front Panel Key Reference
2-88 User’s Guide for DSA1000 Series
2.5.4.1 Next Peak
Searches the peak whose amplitude is the closest to that of the current peak and
meets the searching condition in Search Para. The peak is then identified with a
marker.
2.5.4.2 Peak Right
Searches the nearest peak located to the right side of the current peak and meets the
searching condition. The peak is then identified with a marker.
2.5.4.3 Peak Left
Searches the nearest peak located to the left side of the current peak and meets the
searching condition. The peak is then identified with a marker.
2.5.4.4 Min Search
Searches the peak with the minimum amplitude on the trace and identifies it with a
marker.
2.5.4.5 Peak Peak
Executes the peak search and minimum search and identifies the results by a pair of
markers. Note that the result under peak search is identified with a Delta Marker and
the other is identified with a Reference Marker.
2.5.4.6 Cont Peak
Enables or disables the Cont peak search, the default is Off. When enabled, the
system will always execute a peak search automatically after each sweep in order to
track the signal under measurement.
To Next Page
Loading...
