09/2016 Page 27 5IN2371 C
Entering the Installer Programming Menu at Initial System Setup
After initial system power-up, language, time and date setting, viewing enabled
zones and defining system partitions, you’ll be in the installer Programming menu,
at Auto Settings.
IMPORTANT: After you finish initial system setup programming tasks from the
installer Programming menu, in order to exit you must perform the procedure for
Step 2: Exiting Installer Programming Menu after Initial System Configuration, page 52.
Subsequently Accessing Installer Menus
After exiting the installer Programming menu (after you finished programming in
it the first time), if you subsequently ever want to access this menu again (or to
access other installer menus, such as the installer Maintenance menu for testing),
make sure you set DIP switch 2 to OFF, otherwise it will reset the installer,
sub-installer and Grand Master codes to factory defaults. If you want to program
from the installer Programming menu again, another option is to do so from the
Configuration Software.
Step 2: Powering-Up and Initializing the System
When a new system is powered-up the first time, here are the initialization steps:
1: Initial power-up & language selection. The system automatically connects to the
Cloud.
2: View enabled zones, define the maximum number of system partitions, and set
the time & date.
Initial System Power-Up and Language Selection
NOTE: During regular system operation (after initial system setup) the language
can be subsequently changed by pressing + 9 simultaneously.
To initially power-up and select a language:
1. Power-up the main panel; the keypad panel takes a few seconds to initialize
(there may be an automatic 3-minute upgrade that runs automatically, during
which the upgrade and power icons may display on the keypad – make sure
you do not disconnect).
2. Press when prompted.
3. Scroll to select a language, and then press OK ( ).
To Next Page
Loading...
