09/2016 Page 50 5IN2371 C
Step 9: Configuring Common System Parameters
Defining System Users
As the installer, you must set up permissions for all the system users – the partitions
each user is allowed to operate, and the authority level for each user, and designate
the code length (see the ProSYS Plus Installation and Programming Manual), however
the Grand Master will set the actual numerical codes for each user. The installer can
also change default installer, sub-installer and Grand Master codes.
Defining User Codes
To define user codes:
1. From installer Programming menu go to: 4)Codes > 1)User, then press .
2. Scroll to a user’s index number (1—500 users possible), then press ; the user
number and “1) Partition” display.
3. Press . To assign the partition(s) this user will be allowed to operate, do the
following:
a. While scrolling through each block of 10 partitions, select partition(s) to allow
operation by this user by entering a partition number to select it (it will
display), or by entering the number again to clear it (it will not display).
b. When finished selecting all partition numbers press .
4. To assign an authority level for this user, do the following:
a. After assigning partitions (step 3), scroll to 2)Authority, then press .
b. Press to go to the authority level for this user (User, Arm Only,
Maid, Unbypass, Guard, Duress, UO Control, Master), then press .
Changing the Default Installer Code
The default installer code is 1111. You can either use this code during system
programming, or you can change it.
To change the installer code:
1. From the installer Programming menu select 4)Codes > 3)Installer, and then
press OK ( ); CODE: 1111 displays.
2. Scroll to each digit and enter a new code, then press .
3. Re-enter the new code, and then press .
To Next Page
Loading...
