09/2016 Page 29 5IN2371 C
Viewing & Updating Zones and Defining Partitions after Initialization
After system initialization, you can view the total number of enabled zones, define
partitions, and also manually update the system with any additional zone licenses
purchased via the RISCO Store and activated using HandyApp -- this can be
useful, for example, if during system initialization the automatic connection to the
Cloud fails.
To view enabled zones after system initialization:
1. Enter your installer code (default is 1111).
2. From the installer Programming menu, go to: 1 > 5 > 7 (System > Settings >
Licenses), and then press OK ( ).
3. Scroll to 1) View Licenses to view the total number of enabled zones (the default
of 64 zones plus any additional zone licenses purchased via the RISCO Store
and activated using HandyApp), and then press .
NOTE: The panel must be connected to the Cloud in order to display the total
number of enabled zones, otherwise only the default number (64 provided
zones) will display.
To update the system with new zone licenses after system initialization:
To manually update the system with the new zone license information (for any
new zone licenses that were purchased via the RISCO Store and activated using
HandyApp), scroll to 2) D/L Licenses and then configure the Cloud-connectivity
parameters.
To define the partition quantity after system initialization:
1. Go to: 1 > 5 > 8 (System > Settings > Partition Qty, and then press ;
MAXIMUM PARTITIONS? 08 (08—32) displays.
2. Enter the maximum number of partitions to enable in the system – the default is
08 (meaning up to 8), but up to 32 can be selected. If you want more than 8
partitions, enter the number. Now press .
To Next Page
Loading...
