Risco ProSYS Plus - Defining APN Automatically and Manually; IP Modules; Setting Dynamic IP; Static IP; PSTN Modem Module

09/2016 Page 33 5IN2371 C
Defining APN Automatically and Manually
After the SIM card is installed and upon establishing GSM/GPRS communication,
the system’s auto-APN feature will automatically configure the APN definitions.
However, there may be cases where you will need to manually define the APN by
entering the APN (Access Point Name) code supplied from the cellular provider,
user name, and password.
NOTE: If any of the APN definition fields are populated manually, the auto-APN
feature will not operate.
 To manually set the APN definitions:
1. From the installer Programming menu, select: 5 > 1 > 2 > 2 > 1
(Communication > Method > GSM > GPRS > APN code), then press OK ().
2. Enter the APN code, and then press .
3. Scroll to 2) APN User Name, press , enter the user name, and press .
4. Scroll to 3) APN Password, press , enter the password, and press .
IP Modules
1. From the installer Programming menu select 7> 1> 2, scroll to 11) IP, and then
press OK ().
2. Press to toggle to the type of IP module installed (or select NONE to
cancel its allocation), and then press .
Setting Dynamic IP / Static IP
Go to: 5 > 1 > 3 > 1 > 1, scroll to either 1) Dynamic IP or 2) Static IP, then press .
PSTN Modem Module
1. From the installer Programming menu, select 7> 1> 2, scroll to 12) Modem, and
then press OK ().
2. Press to toggle to Modm (or select NONE to cancel its selection), then
press .
Long-Range Radio Transmitter Module
See the ProSYS Plus Installation and Programming Manual and the LRT module’s
instructions.
1. From the installer Programming menu select 7> 1> 2, scroll to 14) LRT, and
then press OK ().
2. Press to toggle to the type of LRT module installed (or select NONE to
cancel its allocation), and then press .