Risco ProSYS Plus - Wireless Expanders; Proximity Key Readers; Voice Module

09/2016 Page 36 5IN2371 C
Wireless Expanders
1. From the installer Programming menu, select 7> 1> 2, scroll to
05)WL Expander, and then press OK ().
2. Scroll to, and then edit the WL expander’s physical ID number to match its DIP
switch settings (see Describing Installer-Set ID Numbers for Bus Devices, page 18).
3. Press to toggle to WM (wireless module), or select NONE to cancel its
allocation, and then press .
4. Press to toggle to Y or N for the bypassing box tamper, then press .
Proximity Key Readers
1. From the installer Programming menu, select 7> 1> 2, scroll to 06)Prox Key Rd,
and then press OK ( ).
2. Scroll to, and then edit the PRK’s physical ID number to match its DIP switch
settings (see Describing Installer-Set ID Numbers for Bus Devices, page 18).
3. Press to toggle to PRK (Proximity Key Reader) or select NONE to cancel
its allocation, and then press ; the Mask screen displays where you can enable
operability of specific partition(s) when using this PKR.
4. While scrolling through each block of partitions, designate the partition(s) to
allow operation via the PKR. Enter a partition number to select it (it will
display), or enter the number again to clear it (will not display), then press .
5. Scroll through the various “Controls” options and toggle between Y and N for
each using , and then press .
6. Repeat this procedure from step 2 for all additional PKRs.
Voice Module
The ProSYS Plus supports 1 voice module.
1. From the installer Programming menu, select 7> 1> 2, scroll to
07)Voice Module, and then press OK ( ).
2. Press to toggle to T=Voice (the Voice Module), or select NONE to cancel
its allocation), and then press .
3. Enter the 2-digit R. Phone Code (remote phone code), and then press .
4. Scroll to select a language for voice announcements, and then press .