Riverstone Networks RS 3000 User Manual

4-14 Riverstone Networks RS 3000/3100/3200 Switch Router Getting Started Guide
Setting Up Passwords Initial Configuration
Here is an example:
5. When the RS 3000, RS 3100 or RS 3200 finishes booting, enter the following commands (when
prompted, answer
yes):
6. The User, Enable, and Diag access mode passwords are now reset to the default “blank” values.
7. Enter new passwords for the User, Enable, and Diag access modes.
boot <image name> skipconfig=yes
rs-boot> boot /pc-flash/boot/ros80 skipconfig=yes
rs> enable
rs# copy startup to scratchpad
rs# config
rs(config)# system set password login none
rs(config)# system set password enable none
rs(config)# system set password diag none
rs(config)# save startup
Are you sure you want to overwrite the Startup configuration [no]? yes
There are non-committed configuration changes. Do you want to make
these changes active and then save everything to Startup [yes]? yes
%CONFIG-I-SAVED, 2001-10-02 21:53:54 %GATED-I-RECONFIGDONE, Routing
configuration changes completed (pid 0x809eab20).
configuration saved to Startup configuration.
rs(config)#

Riverstone Networks RS 3000 Specifications

General

Brand	Riverstone Networks
Model	RS 3000
Category	Network Router
Language	English