Riverstone Networks RS 3000 User Manual

Riverstone Networks RS 3000/3100/3200 Switch Router Getting Started Guide 3-17
Hardware Installation Installing the Hardware
3.3.7 Management Ports
The RS 3000 has two ports for attaching management devices:
Male DB-9 DCE port – This serial port is used for direct connection to a terminal or PC running terminal emulation
software. Use this port to perform basic setup using the Command Line Interface (CLI).
RJ-45 10/100Base-T DTE port – This Media Data Interface (MDI) port is used for in-band management of the
RS 3000 through a Telnet session to the CLI or through SNMP.
Connecting the Serial Management Cable
Use the serial cable to connect the RS 3000, RS 3x00 or RS 3200 to a terminal (or to a PC running terminal emulation
software) to perform initial setup and configuration. The RS 3000, RS 3x00 or RS 3200’s serial cable is a female to
female DB-9 crossover cable. Figure 3-13 shows the serial port on the front of the RS 3000, RS 3x00 or RS 3200, and
Figure 3-14 shows the serial port’s pin-out. Table 3-3 maps the wiring of the serial cable
Figure 3-13 RS 3000/RS 3x00/RS 3200’s serial (DB-9 DCE) management
port
Figure 3-14 Serial port (DB-9 DCE) pin-out
Table 3-3 Wiring map for serial cable
Signal (RS 3x00 serial port) Pin Signal (management console port)
Unused 1 Unused
TXD (transmit data) 2 RXD (receive data)
a
RXD (receive data) 3 TXD (transmit data)
3
4
21
1000BASE-SXG2M-GSXA1-02
Tx
Rx
Link
AN
Tx
Rx
Link
AN
RS 3000
Serial
Management Port
21
1000BASE-SXG2M-GSXA1-02
Tx
Rx
Link
AN
Tx
Rx
Link
AN
2
1
CONSOLE
10/100 MGMT
OKERR
DIAG HBT
RST
1
5
69

Riverstone Networks RS 3000 Specifications

General

Brand	Riverstone Networks
Model	RS 3000
Category	Network Router
Language	English