Riverstone Networks RS 3000/3100/3200 Switch Router Getting Started Guide 3-1
3 HARDWARE INSTALLATION
This chapter provides hardware installation instructions and information on safety considerations, environmental
considerations, and regulatory standards.
3.1 SAFETY CONSIDERATIONS EN ESPANOL -- APPENDIX B
Read the following safety warnings and product cautions to avoid personal injury or product damage.
3.1.1 Preventing Injury
Observe the following safety warnings to prevent accidental injury when working with the RS 3000, RS 3x00 and
RS 3200 hardware:
• Be careful when lifting the RS 3000, RS 3x00 or RS 3200 out of the shipping box.
• Never attempt to rack mount the RS 3000, RS 3x00 or RS 3200 unaided. Ask an assistant to
help you with the RS 3000, RS 3x00 or RS 3200.
• Before performing any mechanical upgrade or installation procedures, make sure that the
RS 3000, RS 3x00 or RS 3200 is powered off.
• Never operate the RS 3000, RS 3x00 or RS 3200 with exposed expansion slots.
• Never operate the RS 3000, RS 3x00 or RS 3200 if it becomes wet or the area where it has been
installed is wet.
• If the chassis is to be installed in a closed or multi-unit rack, make sure that the ambient
temperature around the unit does not exceed the temperature range listed in Table 3-1.
• Install the chassis as low as possible in the rack to prevent tipping of the rack.
3.1.2 Preventing Equipment Damage
To prevent damage to the RS 3000, RS 3x00 or RS 3200 components, observe the following warnings.
Warning Always use proper electrostatic discharge (ESD) gear when handling line
cards or other internal parts of the RS 3000, RS 3x00 or RS 3200.
To Next Page
Loading...
Need help?
General
