Riverstone Networks RS 3000 User Manual

5-2 Riverstone Networks RS 3000/3100/3200 Switch Router Getting Started Guide
Upgrading System Image Software Managing Software
Note The <image-file-name> is the full directory path and filename to the image
software file on the TFTP server.
Here is an example:
4. Enter the system image list command to list the images on the internal flash memory and verify
that the new image is present.
Here is an example:
5. Use the system image choose command to select the image file that the RS 3x00 will use when
rebooted.
Here is an example:
6. Use the system image list command to verify the change.
system image add <IPaddr-of-TFTP-host> <image-file-name>
rs# system image add 134.152.178.5 tftpboot/ros8100
Downloading image 'tftpboot/ros8100' from host '134.152.178.5'
to local image ros8100 (takes a while) . . .
download: done
save:
kernel: 100%
done
Image checksum validated.
%SYS-I-BOOTADDED, Image 'ros8100' added.
rs# system image list
Images currently available on Master CM
slot0:
ros8100 (version 8.1.0.0)
ros8000 (version 8.0.0.0) [selected for next boot]
rs#
system image choose ros8100
Found image in slot0
Making image ros8100 (version 8.1.0.0) the active image
for next reboot on Master CM . . .
%SYS-I-CHS_PRIMARY_OK, image successfully chosen on Primary CM
rs#

Riverstone Networks RS 3000 Specifications

General

Brand	Riverstone Networks
Model	RS 3000
Category	Network Router
Language	English