Riverstone Networks RS 3000 User Manual

5-6 Riverstone Networks RS 3000/3100/3200 Switch Router Getting Started Guide
Loading Software from the Network Managing Software
Here is an example:
6. Enter the set command to view the changes:
Here is an example:
7. From the Boot prompt, use the ping command to verify that the RS 3000 can reach the TFTP server.
8. Reboot the RS 3000, RS 3100 or RS 3200. As the RS 3x00 initializes, it ignores the software image
on the internal flash and retrieves its operating software from the TFTP server at
134.152.176.5:
Here is an example:
rs-boot> set netaddr <IPaddr>
rs-boot> set netmask <subnet-mask>
rs-boot> set gateway <IPaddr>
rs-boot> set bootsource <dir-filename>
rs-root> set bootaddr <IPaddr>
rs-boot> set netaddr 134.152.179.132
rs-boot> set netmask 255.255.255.224
rs-boot> set gateway 134.152.179.129
rs-boot> set bootsource /tftpboot/ros80
rs-boot> set bootaddr 134.152.176.5
rs-boot> set
...
netaddr = 134.152.179.132
autoboot = boot
netmask = 255.255.255.224
gateway = 134.152.179.129
bootsource = /tftpboot/ros80
bootaddr = 134.152.176.5
ethaddr = 00:00:1d:12:34:56
sysid = -1
rs-boot>
rs-boot> boot
Rebooting. . .
. . .source: tftp://134.152.176.5/tftpboot/ros80
Build location: host 'matrix' by 'adm'...
Version: 8.0.0.0 . . .

Riverstone Networks RS 3000 Specifications

General

Brand	Riverstone Networks
Model	RS 3000
Category	Network Router
Language	English