Riverstone Networks RS 3000 User Manual

-2 Riverstone Networks RS 3000/3100/3200 Switch Router Getting Started Guide
Configuration changes do not seem to be
taking effect.
Reactivate the changes using the procedure in
Section 4.3.1, "Activating the Configuration
Commands in the Scratchpad."
Configuration changes are not reinstated
after a reboot.
Save the configuration changes to the startup
configuration file using the procedure in
Section 4.3.2, "Saving the Active Configuration to
the Startup Configuration File."
The router is not resolving DNS names. Set up DNS using the procedure in Section 4.7,
"Setting the DNS Domain Name and Address."
Ensure that you can use NS lookup on the DNS
server to get the default domain.
An SNMP manager cannot access the
router.
Set up an SNMP community string and specify a
target for SNMP traps using the procedure in
Section 4.6, "Setting Up SNMP."
Type the
snmp show all in the CLI to check the
SNMP settings.
Use the
traceroute and ping commands to verify
that the router can reach the SNMP management
station.
You are unable to ping a certain host. Create and add an IP or IPX interface for the host.
See the Riverstone RS Switch Router User Guide for
information.
Table A-1 Troubleshooting (Continued)
If you experience this difficulty... Try this remedy...

Riverstone Networks RS 3000 Specifications

General

Brand	Riverstone Networks
Model	RS 3000
Category	Network Router
Language	English