Riverstone Networks RS 3000/3100/3200 Switch Router Getting Started Guide 4-3
Initial Configuration Powering on the RS 3000/RS 3100/RS 3200
4. When the software is fully booted, the following messages appears on the management console:
5. As prompted, press Return (or Enter) to activate the Command Line Interface (CLI) on the console.
Note If prompted for a password, simply press the Return key. The default passwords
are blank.
Note If the message “SYS-E-NOFLASHCARD” appears while booting the RS 3000,
RS 3100 or RS 3200, the system has not detected its internal flash memory. If this
occurs, reboot the system. If the system still does not recognize its memory,
contact Riverstone Networks Technical Support.
Press RETURN to activate console...