Rlide R2 Series - Page 95

93
f.
Enter to the Stake Out Roads screen.
The Operational steps are same as
point stake-out. Rotate the instrument
until the dAZ displays 0° 00'00".
Stake out
Roads
dAZ
48°56’52”
HD:
14.972m
* Sight Press [MSR]
OK
g.
Sight the target and then press [MSR 1]
or [MSR 2].
[MSR 1]/
[MSR 2]
Stake out
Roads
dAZ
0°00’00”
HD:
15.962m
* Sight Press [MSR]
OK
h.
After measuring, the deviation value
between measure point and stakeout
point is shown. ※2), ※3)
dHA：Difference in horizontal angle to
the target point
R/L: Right/Left (Lateral error)
IN/OUT: In/Out (Longitudinal error)
CUT/FIL: Cut/Fill
Stake out
Roads
1/8
dHA
0°00’00”
STP
0.000m
IN
13.971m
FIL
0.743m
* Press [ENT] Rec
i.
Ask the rodman to adjust the target
position, making R/L and IN/OUT to
display 0 m.
：moving towards to station
：moving away from station
Stake out
Roads
1/8
dHA
0°00’00”
STP
0.000m
IN
0.000m
FIL
0.743m
* Press [ENT] Rec
j.
When both R/L and IN/OUT display 0m,
it indicates the prism is on the stakeout
point.
The fifth line shows the data of fill or dig.
Stake out
Roads
1/8
dHA
0°00’00”
STP
0.000m
IN
0.000m
FIL
0.201m
* Press [ENT] Rec