Rlide R2 Series - Page 96

94
k.
After staking out, you can press [ENT] to
record the stakeout point. PT defaults to
the last recorded PT+1, you can input
code if necessary. Press [ENT] to record
the point.
[ENT]
N:
10.000m
E:
10.000m
Z:
6.180m
ST:
221
CD:
List
Stac
Explanation for the Alignment Stake-Out screen:
CH:
1.000
O/S:
0.000m
dVD:
0.000m
* Press [MENU] Slope SO
LOFS
ROFS
+CHG
-CHG
LOFS：This key is used to stake out left chainage. Press it to display the offset and the height
difference of the left chainage.
ROFS：This key is used to stake out right chainage. Press it to display the offset and the height
difference of the right chainage.
+CHG：The key is used to increase the chainage.
-CHG：The key is used to increase the chainage.
7.7.10 Slope Stake-out
Slope Stake Out can be launched as part of the Alignment Stake-Out. It is a must to define horizontal and
vertical alignments in Road menu previously. In stake-out main screen, press [menu] to enter into slope
stake-out function.
Slope stake-out screen：
Slope
SO
(1:N)
Cut L:
0.000
Fill L:
0.000
Cut R:
0.000
Fill R:
0.000
The fill/ cut value that are input here is a ratio.
The fill/dig data can be entered through left and right slopes. In terms of fill/dig, use positive symbol to input
the required slope, the software selects an appropriate slope in the list according to the actual position of
the point.