Robustel R5020 Hardware Manual
RT064_HM_R5020 3/11
Radio Specifications for Europe
3G: WCDMA: B1/B2/B3/B4/B5/B6/B8/B19
4G: LTE FDD: B1/B2/B3/B4/B5/B7/B8/B12(B17)/B13/B14/
B18/B19/B20/B25/B26/B28/B29/B30/B32/B66/B71
LTE TDD: B34/B38/B39/B40/B41/B42/B43/B48
LAA: B46
5G: NSA/SA: n1/n2/n3/n5/n7/n8/n12/n20/n25/n28/n38/n40/
n41/n48/n66/n71/n77/n78/n79
2.4 GHz: 2.412 - 2.472 GHz
5 GHz: 5.15 - 5.825 GHz
23 dBm ±2 dB@5G, 23 dBm ±2 dB@4G, 24 dBm +1/-3 dB@3G, 18 dBm@Wi-Fi
* May vary on difference models.
Note: The 5150 to 5350 MHz frequency range is restricted to indoor use only in.
電波法の規定により 5GHz 帯は屋内使用に限ります。
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s) and Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.