ROCAMED MH01 - Environmental Conditions and Installation; Environmental Condition; Working Area; Electrical Connection Requirements

22
NOTE-MH01-EN rev05
4 ENVIRONMENTAL CONDITIONS AND INSTALLATION
4.1 Environmental condition
4.1.1 Working area
Warning:
The working area must be marked with warning labels laser, so as to prevent
accidental entry into the area. All windows, mirrors, metal and other reflective
objects (clocks) should be covered, so as to avoid distortions of the laser beam. All
staff in the working area should know how to turn off the laser system in case of
emergency.
The use of mobile phones is prohibited in the working area while using the device,
because it could interfere with its proper operation.
Be careful that the laser system key is in a safe place when not in use.
4.1.2 Electrical connection requirements
The device must be connected to the electrical system in compliance with electrical safety
regulations.
In accordance with safety Standards, the device is normally supplied with a cable with
different plug related to the different countries and models:
· 115V, Nema L5-20P
· 230V, Shuko
WARNING!
To avoid risk of electric shock, this equipment must only be connected to a supply
mains with protective earth.
4.1.3 Temperature and humidity
Appropriate values of temperature and humidity are required for the proper functioning of
the device. The working temperature of the device should be between 10°C and 30°C, while
the humidity should not exceed 85%.
4.1.4 Minimum space requirements
To ensure proper device ventilation it must be stand with at least 50cm of free space on both
sides. This laser device is easily moved from room to room. Check in every room there is the
minimum space required and the electrical proper.
4.2 Device installation
The device installation requires that safety precautions are followed, the power
requirements and the environmental conditions in the working area.
The installation of the laser device must be performed by qualified technical personnel
authorized by the manufacturer. This person should also carry out tests on the operation of
the device after installation in the designated working area.