ROCAMED MH01 - Lithotripsy Mode

33
NOTE-MH01-EN rev05
5.2.3 Lithotripsy Mode:
If you select “Lithotripsy” in the first mode emission selection (cap5.2.2) the following
screen will appear:
Select the type of stone object of the treatment
After the selection of the chemical
composition of the stone, it is possible to
choice the desired lithotripsy effect: Dusting
(Long Pulse), Fragmentation (short Pulse).
Use the Lithotripsy Dusting Effect Mode in
order to minimize the size of fragments.
Use the Lithotripsy Fragmentation Mode in
order to minimize the speed of lithotripsy
but doing bigger size of fragments
MH01 will suggest you a combination of energy pulse
and frequency emission*, taking in consideration your
selection and the connected fiber specifications.
The operator have to intend these pre
-sets
1
just as
suggestion and he can change the frequency and the
energy before the use over the target stone
.
The final output setting is under the responsibility to the
operator.
1
The pre-set combination are been suggested by Prof. Olivier Traxer
Select the Type of stone to treat:
- CaOx MonoHydrate
- Cystine
- Uric Acid
- CaOx DiHydrate
- Struvite/Infectious
- Other