ROCAMED MH01 - Emptying the Hydraulic Circuit

28
NOTE-MH01-EN rev05
WARNING:
Do not activate the system with the bleeding tube
connected.
· Turn the device on and check again the water level.
· Refill if necessary until reaching an optimal level.
IMPORTANT!
Check periodically the water level using the graduate scale and refill as necessary following
the above instruction
4.2.12 Emptying the hydraulic circuit
The procedure for emptying the hydraulic circuit is the following:
Turn off the System
Insert the blue tube supplied in the
water drain connector (1).
Place a container to collect the water
released from the tube.
When the emptying is over remove
the tube and push in red cap to close
the Air Purge
1
2
1
1