24
NOTE-MH01-EN rev05
4.2.2 Packaging
The laser system is normally shipped in a specific carton on wood pallet. Upon the container
arrival, it will be a client responsibility to be reviewed and to do pre-positioned by the
responsible technician for installation near the working area.
4.2.3 Inspection
It’s important that the received material is inspected immediately upon arrival on the
following terms:
· Administrative check:
Number of packages
Sizes and weights
· Technical check:
Packaging condition
These checks must be made visually, with the greatest possible care and in the presence of
the carrier.
4.2.4 Labelling check
Verifying Labelling the integrity and readability of the security labels placed on the device
is responsibility of the user. If labels are damaged, they must be replaced immediately
comply with the labelling shown in the label plan (Chapter 2.13).
4.2.5 Installation procedure
The installation procedure must be performed each time the device is installed for the first
time or after being transported by means of cars, elevators, trucks, air cargo, etc.
During installation the device must be checked for proper operation and possible malfunctions
after transportation of the laser device must be corrected.
The installation procedure includes also a training course from the distributor to the user
concerning the use of the medical device.
The first turn on procedure typically takes several hours, during this time the access to the
installation site is forbidden. The case is normally shipped to the distributor.
It is extremely important that the packed materials be checked immediately upon their
arrival, if possible, in the presence of the shipper’s delivery employee, as follows:
· Open the packaging and put the laser device in a proper site for a general check.
· Execute the following operations for the general check:
o Check the labels of the device
o Remove the label “Caution no water inside”
o Connect the remote door interlock
o Connect the footswitch
o Fill the system cooling liquid with bidistilled or deionized water only
o Connect the laser device to the power supply
o Turn on the system
o Check the system and verify if alert messages are displayed
o Connect the RFID Fibers and wait that MH01 system recognizes type and the number
of uses of employed fibers.
To Next Page
Loading...