2 • Powering Up and Entering an Operator ID
36
Adjusting the display Using the Display options, you can adjust the display con-
trast to the ambient light conditions.
1 In the Power Up screen, touch Contrast. The Display
screen appears.
2 Touch or to make the display lighter or
darker.
3 Touch to confirm the setting.
Enabling/disabling wireless
connectivity
If the meter supports wireless connectivity, you can tem-
porarily enable or disable this functionality as required.
Wireless connectivity is automatically reactivated the next
time you power on the meter. You can then disable it
again temporarily, if required.
After 30 seconds without any activity (e.g., without a
screen touch) the meter automatically dims the dis-
play backlight to conserve energy (“Low Power
Mode”).
Display
Lighter Darker
12:48 pm
09/18/13
WARNING
If you suspect that the RF emissions of wireless commu-
nication are harming the patient or affecting other
devices, you should carefully reassess the appropriate-
ness of continued use of the WLAN functionality of the
Accu-Chek Inform II system using the guidelines of your
facility.
To Next Page
Loading...
Need help?
General
