Appendix • A
161
A Appendix
A.1 Table of configuration options
This section provides an overview of all the settings
available.
The two rightmost columns describe the accessibility of a
configuration parameter on the device (Setup Menu) and
via the data management system (DMS).
“Y” (Yes) means, that this parameter is available, “N” (No)
means, that this parameter is not available using the
respective configuration method.
Configuration options
DEVICE: If the meter is configured by a system admin-
istrator using a data management system, the config-
uration options on the meter may be disabled to avoid
conflicts in the settings. This option is indicated by the
use of parentheses e.g., (Y).
DMS: Configuration options may vary depending on
available DMS settings.
Subject/Attribute Range Default Device DMS
Timer
Shutdown timeout (meter powers off if no
activity)
30 – 3,600 s 300 N Y
Beeper
Beeper volume 0: low
1: medium
2: high
2YY
To Next Page
Loading...
Need help?
General
