4 • Glucose Control Testing
64
Confirming or selecting the test
strip lot
Once you have entered and confirmed the lot number of
the control solution, you are asked to choose the lot
number for the test strips. Compare the number dis-
played by the meter to the number on the label of the test
strip vial.
1 Select the lot number as follows:
■ To read the lot number from the test strip vial via
barcode scanner, press and release . Follow
the instructions for scanning IDs. *
■ If you want to use the preselected lot number dis-
played by the meter, touch to confirm.
■ To use a different lot number than the one dis-
played, touch to display a list of stored lot
numbers. Select the desired lot number from the
list.
2 Touch to confirm the selected test strip lot
number.
For additional information about storing lot numbers for
test strips, see page 73.
* Barcodes on control solutions may not be available in all
countries (see page 47).
The meter can be configured so that manual
confirmation is not necessary. In this setup, only the
lot number is displayed. Additional options are not
available.
The meter can be configured so that lot numbers are
entered via barcode scanner only. *
The meter can be configured so that lot numbers can
only be selected from a list.
Control Test
Control L2 (Hi) 123456
Use Strip L
ot
12:48 pm
09/18/13
123456?
Strip Lots
344789
545794
545777
344654
12:48 pm
09/18/13
To Next Page
Loading...
Need help?
General
