IMPORTANT: ALWAYS MAKE SURE THAT THE ZERO POINT IS SET CORRECTLY!
There are three possible variants:
1. ZP = 0 and XP = 0 In this case, the movement after the START signal goes after a safety
query to X 0,00 and then in -Z direction until the STOP key is pressed. START-STOP operation
is possible while the vehicle is moving. Only when the STOP button is pressed does the move-
ment abort, after which X and Z are reset to the stop position.
2. ZP <> 0 XP = 0, therefore only one end position for Z is specied, no depth.
Here the movement goes directly after the START signal WITHOUT safety query to X 0.00 and
then in -Z direction to the end point Z P. Then a reset to X 0.2 and back to Z 0.00 takes place,
then the position for X and Z changes to the hold position.
3. ZP < 0 and XP < 0, so the values for length and depth are given here.
The control cuts fully automatically in several passes. After the START signal, the control rst
displays an overview of all the data for the individual passes. A new START command starts the
cut, STOP aborts the process. After the last pass has been completed, the X axis is moved to
+0.2 and the surface at the end of the workpiece is turned cleanly at. Then the stop position
is approached.
59
To Next Page
Loading...