Index-2
PowerFlex® 755 Drive Embedded EtherNet/IP Adapter User Manual
Publication 750COM-UM001A-EN-P
equipment required, 1-3
Ethernet
cable
, 2-4
connector on adapter, 1-1
switch, 2-4
Ethernet Link object, C-36
EtherNet/IP
data rates
, A-1
example network for
ControlLogix
, 4-2
MicroLogix 1100, 4-37
PLC-5, 4-21
SLC 500, 4-29
network definition, G-2
objects, C-1
specification, G-2
events
clearing/viewing
, 7-5
list of, 7-5
explicit messaging
about
, 6-1
configuring for
ControlLogix
, 6-3
MicroLogix 1100, 6-32
PLC-5, 6-14
SLC 500, 6-18
definition, G-3
performing, 6-2
F
fault action
configuring the adapter for
, 3-14
definition, G-3
fault configuration
configuring the adapter for
, 3-15
definition, G-3
faults, see events
features, 1-2
firmware release, P-2
flash update
definition
, G-3
guidelines, 3-18
Flt Cfg DL 01-16 parameters, B-7
Flt Cfg Logic parameter, B-6
Flt Cfg Ref parameter, B-6
Fr Peer Addr 1-4 parameters, B-8
Fr Peer Enable parameter, B-8
Fr Peer Status parameter, B-8
Fr Peer Timeout parameter, B-8
full duplex, see duplex
G
gateway, G-3
gateway address
setting with BOOTP
, 3-2
setting with parameters, 3-5
Gateway Cfg 1-4 parameters, B-4
H
half duplex, see duplex
hardware address
definition
, G-3
in diagnostic item, 7-4
on label, 3-2
HIM (Human Interface Module)
accessing parameters with
, 3-1
definition, G-4
hold last
configuring the adapter for
, 3-14
definition, G-4
host IDs, G-4
I
I/O
about
, 5-1
configuring for
ControlLogix
, 4-2
MicroLogix 1100, 4-37
PLC-5, 4-21
SLC 500, 4-29
definition, G-4
limitations when using
MicroLogix 1100
, 4-20
PLC-5, 4-20
SLC 500, 4-20
understanding the I/O image, 5-2
using with
ControlLogix
, 5-6
MicroLogix 1100, 5-14
PLC-5, 5-14
SLC 500, 5-14
Identity object, C-2
idle action, G-4
Idle Flt Action parameter, B-5
installation
applying power to the adapter
, 2-4
commissioning the adapter, 2-6
connecting to the network, 2-4
preparing for, 2-1
IP Addr Cfg 1-4 parameters, B-3
To Next Page
Loading...
Need help?
General
