R&S PB Installation Instruction CMU-B41 AUDIO-GEN.+ANA. Bi/1CMK 18.11.99 1100.5397.00 02.00
page 5 of 7
2.1 Cabling
The option has the electrical designation A 11.
When installing the option CMU-B41, observe that the designations of built-in cables for batches 831593...,
829740..., 830377..., and 828942... are not complete or incorrect and so the cables have to be identified
according to the following list.
Source Incomplete Connecting end
cable designation
Loudspeaker cable A11-X A11/X112 *
AF IN cable W 6 A11-X114 A11/X113 *
AUX 1 cable W 8 A11/X114 *
AF OUT cable W 5 A11-X113 A11/X115 *
AUX 2 cable W 7 A11/X116 *
½ Connect the supplied RF cable as follows:
RF cable W 40 1st end to A11/X119 *
2nd end to A10/X105 *
RF cable W 34 1st end to A11/X117 *
2nd end to A7/X704 *
* The connector designation X .... is inscribed on the board, the cover of the audio board and the service label.
To Next Page
Loading...
Need help?
General
