Rohde & Schwarz CMU200 - Modification of Universal Link Handler

R&S PB Installation Instruction CMU-U53 BLUETOOTH_F.CMUBi/1CMK 08.09.00 1100.7383.00 01.00
page 5 of 11
3 Modification of Universal Link Handler
 Remove the two screen covers after undoing the screws (Fig. 4).
 If the TAZ (update state) of the Link Handler base plate (1097.3570.02) is lower than -03.06-, modify as
shown in Fig. 5.
 The update status (TAZ) can be seen on the barcode label stuck to the solder side of the board inside the
screening strip.
 If the TAZ of the Link Handler base plate in slot A430 (1097.3570.02) is lower than -03.06-, modify the top
screen cover (labelled) as shown in Fig. 6.
 If the update status (TAZ) of the I/Q Out module on slot A430 (1100.2000.02) is lower than –03.08-, modify
as shown in Fig. 7.
The update status (TAZ) is visible when the covers are removed.
 If the optional Speech Codec CMU-B52 (1100.5400.02) is fitted, remove the module in slot A420 (it is no
longer required, Fig. 4).
 Insert Bluetooth module 1135.6502.02 (Fig. 4).
 Stick the OPTION INCL. (1100.5797.00) label to the cover at the solder side (Fig. 4).
 Screw back the two screen covers and insert Link Handler into the unit (Fig.3 and 4).