CMU MODULE Replacement
1100.4903.82 3.21 E-4
Putting into operation
½ Connect the instrument to the mains.
½ Connect the external keyboard to the keyboard connector on the rear panel of the CMU.
½ Switch on the CMU.
½ During startup observe the display.
½ When three BEEPs can be heard, press the softkey to the left upper side of the LCD: C:\ will appear.
½ MODEL 04:
• Insert a flash disk with the program FLASH FMR4 (this program is available on R & S Lotus Notes
Service Board) in the PCMCIA slot 0 (right drive D:) or a floppy disk with the program FLASH
FMR4 in the Option FLOPPY DISK DRIVE CMU-U61.
• Start program FLASH FMR4 with D:\ FLASH FM4.BAT or A:\ FLASH FM4.BAT.
½ MODEL 12:
• Insert a flash disk with the program FLASH FMR5 (this program is available on R & S Lotus Notes
Service Board) in the PCMCIA slot 0 (right drive D:) or a floppy disk with the program FLASH
FMR5 in the Option FLOPPY DISK DRIVE CMU-U61.
• Start program FLASH FMR5 with D:\ FLASHFM5.BAT or A:\ FLASHFM5.BAT.
½ During the programming of the flash EEPROM the CMU must not be switched off.
½ When the prompt C:\ appears then switch off and on the CMU.
½ Press the key DEL (Delete) on the external keyboard in order to get into the Setup menu.
½ Choose the item DEFAULT OPTIMAL (MODEL 04) / LOAD CMU-DEFAULTS (MODEL 12) and
press ENTER; quit with y and ENTER.
½ Only if Option FLOPPY DISK DRIVE CMU-U61 is fitted, then choose the item Setup Standard and
set FLOPPY A to '1.44 MB 3 ½'. Exit with the ESC key.
½ Exit Bios Setup with key ESC and quit with y (save changes and exit) and press ENTER.
The CMU starts the operating software automatically, it is ready for use and can be operated as usual.
To Next Page
Loading...
Need help?
General
