EasyManuals Logo

Rohde & Schwarz CMU200 Service Manual

Rohde & Schwarz CMU200
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #157 background imageLoading...
Page #157 background image
R&S PB Installation Instruction CMU-B52 SPEECH_CODEC Bi/1CMK 18.11.99 1100.5474.00 02.00
page 7 of 7
4 Functional Test of Option CMU-B52
½ Connect unit to AC supply and switch on
4.1 Automatic Module Data Adjustment
½ During startup observe the display.
½ When three BEEPs can be heard, press the MENU SELECT key.
The VersionManager is started (see also chapter 4, Firmware update). The display includes the menu item
FIRMWARE UPDATE AFTER BOARD CHANGE.
½ Press the softkey to the left of the above mentioned menu item.
The automatic module data adjustment is performed under software control, firmware updates for
microprocessors and programmable devices being performed as well. This may take a few minutes.
After the adjustment has been terminated, the operating software starts automatically and the CMU is ready
for use and complies with the specifications.
4.2 Test of Option Detect
½ Press SETUP hardkey in SYSTEM panel
½ Press OPTIONS softkey located on the row of keys at bottom of display
½ --> Check whether CMU-B21 is active

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rohde & Schwarz CMU200 and is the answer not in the manual?

Rohde & Schwarz CMU200 Specifications

General IconGeneral
BrandRohde & Schwarz
ModelCMU200
CategoryTest Equipment
LanguageEnglish

Related product manuals