R&S PB Installation Instruction CMU-B71 ABIS INTERFACE UNIT Bt/1CMK 07.02.01 1100.6493.00 01.00
page 5 of 6
3 Assembling Unit
3.1 Putting Cover Back
Fit cover and cabinet feet back on in the reverse order to that described under 1.2/1.3 (Fig. 1).
4 Functional Test of Option CMU-B71
4.1 Connect unit to power and switch on
4.2 Automatic Module Data Adjustment
½ On booting the CMU, watch the display.
½ When you hear three beeps, press the MENU SELECT key.
The VersionManager is started (see also chapter 4 of CMU Service Manual Instrument, Firmware update).
The display offers the menu item FIRMWARE UPDATE AFTER BOARD CHANGE.
½ Press the softkey to the left of the above menu item.
The module data are adjusted automatically under software control and firmware updates are performed for
microprocessors and programmable components. This takes only a few minutes.
After adjustment, the operating software is started automatically. CMU is ready for operation and complies with
data sheet specifications.
4.3 Checking the Option Identification
½ Press the SETUP hardkey in the SYSTEM field.
½ Press the OPTIONS softkey in the row below the display.
--> Check whether CMU-B71 is displayed and activated.
4.4 Function Test
½ Press the MENU SELECT hardkey in the FUNCTION field.
½ Select GSM900 BTS function group, Signalling mode and Overview menu and press the Enter hardkey.
½ Press the A
bis
softkey in the row now appearing below the display.
½ Press the Alarm Monitor softkey in the row to the left of the display.
½ Press the ON/OFF hardkey in the DATA field.
To Next Page
Loading...
Need help?
General
