CMU MODULE Replacement
1100.4903.82 3.27 E-4
MODEL 12:
½ Carefully fit the new hard disk, fasten with the four screws to the disk holder. Insert the hard disk
with the disk holder on the back of the aluminum case of the FRONT MODULE. Be careful with the
lower cover plate locking in the concerning opening.
Connect the ribbon cable to the FRONT MODULE CONTROLLER. Fit the disk holder with two
screws to the aluminum panel of the FRONT MODULE.
½ Complete the instrument without causing damage to the cables.
Putting into operation
½ Connect the instrument to the mains and switch on: The built-in FRONT MODULE CONTROLLER
registers on the LCD. The BIOS is factory-set to the CMU, the new hard disk is automatically
detected.
½ Install the new software (see chapter 4, Firmware update).
To Next Page
Loading...
Need help?
General
